We've checked with Power Gear in the past with your slide out motor number 521066W and found that the correct replacement is the part # LC386327. This would have same performance capabilities as what you have now. view full answer...
We have a few options for you to consider in a platform for your boat trailer tongue. We don't carry a specific walk board, but we do have some similar items like the following:
HitchMate Boat Trailer Step - 5" Wide x 9" Long - 400 lbs # HE4036
CE Smith Galvanized Steel Step for 2" Trailer Frame - 15-1/4" Long x 3" Wide # CE26212G-15284GA
I've attached some videos to assist. view full answer...
The only canopy screens we offer are the Solera Screen Rooms which are specific to Solera Awnings. For example, if you have a 16' Solera RV Awning then you can use the Solera Screen Room for 16' RV Awning part # LC362219. If you can let me know what awning you have and the length I would be glad to see if we have a screen room for you. I have attached a list of our selection below. view full answer...
Since your 2005 Fleetwood Southwind 32V is built on the Ford F-53 Chassis and is under 34' long you will need the Roadmaster Rear Anti-Sway Bar # RM-1139-143.
It is possible that your factory U-bolts will not be long enough, if they are not you will need the # RM-590050-10 if you have round U-bolts or # RM-590050-00 if you have square U-bolts.
You may also be interested in the Front Anti-Sway Bar # RM-1139-148, and Steering Stabilizer # RM33RR to complete your suspension enhancement and... view full answer...
We don't have anything custom fit for your 2005 Southwind 32V but if your frame width is between 24 and 46 inches the # 5350 will fit. Or we have the # 13703 which fits a wider range of 22 and 72 inch and fits all frame styles. view full answer...
Since Atwood is not in the trailer jack business anymore we can't get their replacement parts like we used to. Maybe you could lucky finding a replacement jack laying around but most likely you'd have to go with a new leveling system like the Lippert Ground Control 3.0 # LC358590. view full answer...
We do not repair levelers at this time and since Atwood is no longer in the leveler business it would be time for a new setup like with the Lippert # LC337199. There isn't anyone that we know of that repairs them and their replacement parts are no longer available. view full answer...
Based on my research your 2004 Fleetwood Southwind Motorhome was either built on the Ford Chassis, or the Workhorse Chassis.
If your Southwind was built on the Ford Chassis I recommend the Roadmaster Rear Anti-Sway Bar # RM-1139-143, and Front Anti-Sway Bar # RM-1139-148.
If your Southwind was built on the Workhorse Chassis I recommend the Roadmaster Rear Anti-Sway Bar # RM-1259-108, and Front Anti-Sway Bar # RM-1259-105. view full answer...
Based on the dimensions and picture of your current AC shroud plus the fact it was designed for a Coleman Mach the MaxxAir Shroud part # MA00-325001 would be exactly what you need. view full answer...
When replacing an incandescent turn signal circuit bulb on a vehicle with an LED you would need to install load resistors or you can go with the easier solution of replacing the thermal flasher unit that controls the blinkers with a digital one. I did this on a vehicle years ago and it's much easier than trying to find the correct load resistor. We do not carry digital flasher units though so you would need to source that elsewhere. view full answer...
We probabaly have what you need since most RV taillights use the same styled, but I'd have to see a picture of what you have to know for sure. view full answer...
What you have is a ducted Coleman AC unit with a heat pump, so you'll need to replace the whole unit, including thermostat because there isn't a plug-in option for this unit. To replace your ducted unit and get a new thermostat you'll need to go with the Furrion HE:
- Furrion Chill HE RV Air Conditioner System # FR55PV
The # FR55PV is a 15,000 Btu like you wanted for better cooling, comes with the thermostat, and has a built-in start capacitor for a power boost so it always starts up.... view full answer...
The correct front SumoSpring kit for your 2005 Fleetwood Southwind 32VS is the SumoSpring kit part # SSF-171-40-2. And then for the rear you'd want the # SSR-187-54-1 and you'd be set. view full answer...
To convert your Dometic manual awning to a power unit, you can use the Solera 12V Conversion Kit in Black # LC434723 or White # LC434724 if you have a manual crank system.
These Solera kits are compatible with Dometic (A&E) awnings like what you have. All of the necessary hardware is included.
The kit you mentioned would not work. view full answer...
For a double step that will fit in replacement of your Kwikee 32 steps part # LC372261 you'd want the Hickory Springs Manual Pull-Out Steps # 98224EXTALC1 as this is only model we carry that's the correct width. view full answer...